Leeson DC Controls

Leeson DC Controls

DC Controls

SCR Series – These are General Purpose drives designed for use with Permanent Magnet or Shunt wound DC motors. NEMA 1 enclosed drives are suitable for most industrial applications. The NEMA 4X controls are best suited for washdown or outdoor installations or for extremely dusty applications. Chassis only drives are available for building into equipment, machinery or existing enclosures. Most controls have a dual voltage switch allowing the control to be used with either 115 volt or 230 volt, single-phase, input power at either 50 or 60 Hz service. It is important that the proper voltage motor be selected to use with the available power supply.

Regenerative Controls (four quadrant) are available in NEMA 4X enclosures and are typically used where more precise motion control is needed.  These controls also produce both motoring and braking torque regulation.

Dual Mode – Dual Speed Controls are designed to run two DC motors at the same time in either independent mode or Slave/Master mode.

PWM Series – Pulse Width Modulated (PWM) controls are available in NEMA 1 and chassis style units for sub-fractional HP frame motors from 1/40 HP through ¼ HP.  Due to their improved form factor, these PWM controls result in quieter operation, lower operating motor temperatures, longer brush life and greater motor overload capacity than for the same motor on an SCR type control.

Low Voltage Series – LEESON’s DC to DC controllers are a chassis type design, that accept a DC input voltage and output a DC power voltage to control the motor’s speed.  A potentiometer is shipped loose with the controls.  On board Trim Pots include calibration, min/max speed, forward and reverse settings and an inhibit circuit for convenient remote starting and stopping.